Home - News - Details

What Is The Difference Between 2205 And 2507 Duplex Steel?

What is the difference between 2205 and 2507 duplex steel?

 

Duplex stainless steel is called "duplex" because its metallographic microstructure consists of two stainless steel grains, ferrite and austenite. In the picture below, the yellow austenite phase is like an "island" surrounded by a blue ocean of ferrite phase. When duplex stainless steel melts, it first solidifies from its liquid state into a fully ferrite structure. As the material cools to room temperature, approximately half of the ferrite grains transform into austenite grains ("islands"). . As a result, approximately 50% of the microstructure is the austenite phase and 50% is the ferrite phase.

Duplex stainless steel is approximately twice as strong as conventional austenitic or ferritic stainless steel. This allows designers to reduce wall thickness in certain applications. The figure below compares the yield strength of several duplex stainless steels and 316L austenitic stainless steel in the temperature range from room temperature to 300°C.

What is the difference between 2205 and 2507 duplex steel?

What is the difference between 2205 and 2507 duplex steel?

Despite their high strength, duplex stainless steels exhibit good plasticity and toughness. The toughness and ductility of duplex stainless steel is significantly better than that of ferritic stainless steel and carbon steel, and it still maintains good toughness even at very low temperatures such as -40°C/F. But it still cannot reach the level of excellence of austenitic stainless steel.

The corrosion resistance of stainless steel mainly depends on its chemical composition. Duplex stainless steels exhibit high corrosion resistance in most applications due to their high chromium content, which favors oxidizing acids, and sufficient amounts of molybdenum and nickel to withstand moderately reducing acids. Corrosion of media.

The ability of duplex stainless steel to resist chloride ion pitting and crevice corrosion depends on its chromium, molybdenum, tungsten and nitrogen content. The relatively high chromium, molybdenum and nitrogen contents of duplex stainless steels give them good resistance to chloride pitting and crevice corrosion. They are available in a range of different corrosion resistance properties, ranging from grades equivalent to corrosion resistance of 316 stainless steel, such as economical duplex stainless steel 2101©, to grades equivalent to corrosion resistance of 6% molybdenum stainless steel, such as SAF 2507©.

Duplex stainless steel has very good resistance to stress corrosion cracking (SCC), which is "inherited" from the ferrite side. The ability of all duplex stainless steels to resist chloride stress corrosion cracking is significantly better than that of 300 series austenitic stainless steels. Standard austenitic stainless steel grades such as 304 and 316 may suffer from stress corrosion cracking in the presence of chloride ions, humid air and elevated temperatures. Therefore, in many applications in the chemical industry where there is a greater risk of stress corrosion, duplex stainless steel is often used instead of austenitic stainless steel.

 

Send Inquiry

You Might Also Like